Announcement

Collapse
No announcement yet.

Retreat Defense- getting started

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 610Alpha
    replied
    There is guy that is doing this right now, he has 2 of them and the rumor is he wanted to build a house on top of them but the powers that be wouldn't let because the containers didn't meet spec on using them as a basement. So he has dirt piled around all the sides, he has a couple of skylights and some railroad ties at the top of the containers kind of framing the openings. I'll try to get some pics while maintaining OPSEC :)

    Leave a comment:


  • eeyore
    replied
    Bearman 202 asked
    I've been thinking about this one lately. My bugout location is off several dirt roads, and I was thinking of building a kind of bunker to provide some protection just in case. I did a little research, and came up with the numbers of blocks needed. Then I started wondering if I might be just as well off getting a dozer and shoving dirt to provide a berm. I could then put a roof on it, leaving some firing slits. The difference is that from a distance, the dirt berm would look like a small hill, whereas a bunker looks like a bunker. The dirt would provide more "ballistic resistance," since some ammo will go right through a cement block. I think by using the berm approach, I could make three pits for the price of one blockhouse. Comments?
    What if you took a conex container, and pushed up dirt on the side of it, then planted some bushes around it? If you had a conex box and used railroad ties or 6x6's covered with ply, that should let you put a couple of feet of dirt on top. This would provide protection from above also, which could be a plus in a bunch of scenarios.
    "Brushed up" after a season, and you would not even be able to see it.



    Leave a comment:


  • 610Alpha
    replied
    Originally posted by Bearman202 View Post
    I did a little research, and came up with the numbers of blocks needed. ~~since some ammo will go right through a cement block. I think by using the berm approach, I could make three pits for the price of one blockhouse. Comments?
    If you are going to use cement blocks you would be better off to fill them with concrete and re-bar to give them extra ballistic protection.

    Like LD3 said about the rain, the only thing you could do to offset that would be to get some good grass with deep roots to help prevent erosion and/or use boulders and then add dirt on top of boulders as well as dig a bit of a pit so that your berm wouldn't have to be too high. Kind of like a foxhole but not as deep but using rocks/boulders underneath the dirt as you real ballistic protection and the prairie grass on top to help prevent soil erosion. Might not work for you but an idea to kick around the forum.

    Leave a comment:


  • Lowdown3
    replied
    Originally posted by Bearman202 View Post
    I've been thinking about this one lately. My bugout location is off several dirt roads, and I was thinking of building a kind of bunker to provide some protection just in case. I did a little research, and came up with the numbers of blocks needed. Then I started wondering if I might be just as well off getting a dozer and shoving dirt to provide a berm. I could then put a roof on it, leaving some firing slits. The difference is that from a distance, the dirt berm would look like a small hill, whereas a bunker looks like a bunker. The dirt would provide more "ballistic resistance," since some ammo will go right through a cement block. I think by using the berm approach, I could make three pits for the price of one blockhouse. Comments?
    Great concept. Having built something like this before, it will work- for a time. The effects of rain will begin to give you problems in a few years.

    No reason a "bunker" has to LOOK like a bunker.

    Leave a comment:


  • Hawkeye
    replied
    Bunker blocks can be used to make some interesting things.......:cool:

    Leave a comment:


  • protus
    replied
    Originally posted by Bearman202 View Post
    I've been thinking about this one lately. My bugout location is off several dirt roads, and I was thinking of building a kind of bunker to provide some protection just in case. I did a little research, and came up with the numbers of blocks needed. Then I started wondering if I might be just as well off getting a dozer and shoving dirt to provide a berm. I could then put a roof on it, leaving some firing slits. The difference is that from a distance, the dirt berm would look like a small hill, whereas a bunker looks like a bunker. The dirt would provide more "ballistic resistance," since some ammo will go right through a cement block. I think by using the berm approach, I could make three pits for the price of one blockhouse. Comments?
    railroad ties.
    stack em. lay em like Lincoln logs for your ports.
    berm dirt up to it
    put a roof on it if you want.

    simple and easy.
    but a solid structure would be best.

    Leave a comment:


  • Bearman202
    replied
    I've been thinking about this one lately. My bugout location is off several dirt roads, and I was thinking of building a kind of bunker to provide some protection just in case. I did a little research, and came up with the numbers of blocks needed. Then I started wondering if I might be just as well off getting a dozer and shoving dirt to provide a berm. I could then put a roof on it, leaving some firing slits. The difference is that from a distance, the dirt berm would look like a small hill, whereas a bunker looks like a bunker. The dirt would provide more "ballistic resistance," since some ammo will go right through a cement block. I think by using the berm approach, I could make three pits for the price of one blockhouse. Comments?

    Leave a comment:


  • 1Admin
    replied
    Originally posted by eeyore View Post
    LD3 said in the original post


    It amazed me a couple of years ago i was helping a friend covered his walk in basement entrance (it clogs up with leaves and floods the basement, but that is another story). When we were trying to put a ledger board on the side of his house. I realized that under the siding was only thin sheet of thermo-ply (1/8 cardboard like material [http://www.berryplasticsbpg.com/prod...rmo-ply-total]) insulation and studs. I realized that they had switched from ply wood on the roof and siding of houses to go to OSB [http://www.berryplasticsbpg.com/prod...rmo-ply-total], but not this stuff. Better check your house when you buy it and realize what you are buying. It made me think how easy it would be to just go thought the siding and come into the house, the metal door on the front with long screws and extra support does not mean much if it is that easy to go through the side.

    Both OSB and Thermo ply are junk (imo) buyer beware

    Couldn't agree more! +1,000

    Leave a comment:


  • eeyore
    replied
    LD3 said in the original post
    Your standard "stick frame" home is made up of a 2x4 or 2x6's, 5/8" or 3/4" plywood, some insulation and sheet rock on the inside and a vapor barrier plus some exterior siding on the outside such as vinyl siding, stucco, brick veneer, a masonry board type product, etc. Practically no "meat" as far as something strong enough to actually stop bullets
    It amazed me a couple of years ago i was helping a friend covered his walk in basement entrance (it clogs up with leaves and floods the basement, but that is another story). When we were trying to put a ledger board on the side of his house. I realized that under the siding was only thin sheet of thermo-ply (1/8 cardboard like material [http://www.berryplasticsbpg.com/prod...rmo-ply-total]) insulation and studs. I realized that they had switched from ply wood on the roof and siding of houses to go to OSB [http://www.berryplasticsbpg.com/prod...rmo-ply-total], but not this stuff. Better check your house when you buy it and realize what you are buying. It made me think how easy it would be to just go thought the siding and come into the house, the metal door on the front with long screws and extra support does not mean much if it is that easy to go through the side.

    Both OSB and Thermo ply are junk (imo) buyer beware

    Leave a comment:


  • eeyore
    replied
    ICF blocks are Styrofoam blocks that you fill with concrete. I had a friend that used them, he wanted them for hurricane reasons (or so he said). It gives you the R value and the strong walls in one package. But what he also found out is once the are poured it is very difficult to change them.

    A while back i looked into a trowel able type material like stucco that has 8000 psi strength,
    http://ogolstorage.com/gigacrete/specs_demos.html This was like something i was looking at "StuccoMax"

    Leave a comment:


  • Lowdown3
    replied
    I looked into the ICF stuff. I know someone in Florida that went that route. I couldn't find anyone up here that did it.

    Also from a "pay cash as you go" perspective, the block ended up better for me. A concrete slab and block walls can sit for a long time in between getting more bucks together for the next phase. You can go and buy 100 blocks at a time, take them home, lay them and then wait for the next paycheck to do some more.

    Sandbags are the way to go. I have an old article somewhere about reinforcing an already built home that Jim Rawles used on SurvivalBlog a long time back, I'll see if I can find it and post it.

    Leave a comment:


  • 610Alpha
    replied
    I have a block wall basement and I wish I didn't. Hydrostatic pressure hasn't been nice to it. I would rather do a solid reinforced concrete wall, i think they call them ICF http://www.icfhomes.com/. I have no idea on the cost, my guess is they aren't cheap.

    So how does one protect their home ballistically without spending 2 arms and a leg to do it? Do you stockpile a bunch of sandbags, sand or 1/2" minus gravel and wait for TSTHTF? We all can't afford Hardened Structures to come build our retreat let along the local ICF contractor.

    Leave a comment:


  • Lowdown3
    replied
    Originally posted by eeyore View Post
    Crossbow is correct, filling block walls is cheaper and putting rebar in the footing and having tie the wall to the footing is a lot stronger then just laying the block on the footing.

    Filling the wall with grout ( or cement mix) is not more trouble then filling the walls with sand or gravel, although a little more expensive.
    Yep. You can rent or have something come out with a pump machine to do it. We used a pump thing that had about a six inch hose that we dragged from cell to cell.

    It's interesting, you drive around the country and you end up seeing dozens of old houses and homesteads from easily 20-100 years ago. All of the wood ones are collapsed in on themselves or in varying stages of collapse. The masonry ones may have their roofs gone but the walls are still intact after decades.

    Worse case scenario, that offers you something that you can camp in while you start rebuilding that still offers you some ballistic protection.

    Leave a comment:


  • eeyore
    replied
    Crossbow is correct, filling block walls is cheaper and putting rebar in the footing and having tie the wall to the footing is a lot stronger then just laying the block on the footing.

    Filling the wall with grout ( or cement mix) is not more trouble then filling the walls with sand or gravel, although a little more expensive.

    Leave a comment:


  • crossbow
    replied
    Originally posted by LizardKing View Post
    Great post.

    I've been wondering if there'd be any real difference between filled block and poured walls. Block would probably be substantially cheaper.
    block filled is a lot cheaper, but for a real strong structure, you could always put rebar right in the footings and drop the blocks over the bar and then fill the blocks also

    Leave a comment:

Working...
X